- Home >
- ProWarm™ foiled faced in joist/batten system
These all in one easy to fit panels (1200mm x 350mm x 50mm) are an ideal solution to fix between existing joists onto battens, they can also be fitted between battens on concrete subfloors, giving you a fast inexpensive solution for installing our pipework (pipework is set at 200mm centers).
Made from EPS (Expanded Polystyrene).
These panels replace the need for using separate spreader plates and separate foil faced insulation systems.
To install the injoist batten system you will begin by securing battens to the sides of the joist with the top of the batten 50mm below the top of the joist. This will allow the insulation to sit flush with the top of the joist.
The pipework can then be placed withing the preformed grooves within the board.
You can finish the installation of this system by installing the finished floor.
Expanded Polystyrene - Grade EPS100 ( BS EN 13163 ).
Panel Dimensions 1200mm x 350mm x 50mm Panel Thickness up to 125mm ( in 1.0mm increments ) Aluminium Foil Thickness 45 microns Thermal Conductivity 0.036 W/mK Compressive Strength 100 kPa @ 10% compression Compressive Strength 45 kPa @ 1% compression Fire Classification Euroclass F
Delivery options Our delivery costs vary according to order size and location. For more information see our Delivery page
Trusted delivery partners
Feefo Reviews - Average 100% (4 reviews)
Date Score Customer Comment Our Response 28-Sep-2015 Product:
Fitting between floor joist which are normally set at 450 mm centre gives a gap of 400 these battens should be 400 wide not 350mm. I have had to support with additional timber and fill in the side gap, otherwise no comment 28-Sep-2015 Product:
As Above 03-Dec-2014 Product:
Good product,quick despatch 22-Jan-2014 Product:
Tile backer board worked well prior to laying underfloor heating, happy with product I would purchase through underfloor heating store and gladly use product again. Read more reviews on Feefo
This product has no reviews yet.