
Standard and high-output kits
Choose the pack that fits the planned heat output and floor construction. Room heat loss and heat-source temperatures guide selection.
Our underfloor heating experts are available weekdays from 7am to 5pm.
All our technical staff are fully qualified to deal with your enquiry. Contact us for expert advice on underfloor heating.
Hep2O water underfloor heating
Our Wavin selection concentrates on Hep2O water underfloor heating: project kits, pipe, manifolds and actuators. Explore each part of the hydronic system and check the floor construction and circuit design before ordering.

The range
Kits help start the specification; pipe, distribution and controls complete it.

Choose the pack that fits the planned heat output and floor construction. Room heat loss and heat-source temperatures guide selection.

Overlay construction can reduce the disruption of a full screed build-up; confirm substrate, height and finish requirements.

Pipe spacing and circuit length are design choices that affect output and flow; follow the system specification.

The manifold distributes water to circuits, while compatible actuators support individual zone control.
Buying guide
Use room-by-room heat loss, available heated area and required floor temperature to decide whether the proposed build-up can deliver the output.
Account for pipe spacing, maximum circuit length, flow and the manifold location. The best layout differs between open rooms and more obstructed spaces.
An overlay renovation and a screeded new build have different depths, response and finishing requirements. Check the complete build-up.
Actuators, wiring centre and thermostats must suit the manifold and required number of zones.
Wavin
Wavin Hep2O Barrier Pipe 10mm & 15mm
Wavin
Wavin Hep2O Underfloor Heating Manifold
Wavin
Wavin Hep2O Water Underfloor Heating - Single Room 15mm Overlay
Good to know
It focuses on the Wavin Hep2O products currently listed in our store. Check each product page for the precise range and components.
Multi-circuit water systems commonly use a manifold to distribute and balance flow. Check the kit contents and the designed number of circuits.
Check the substrate, floor height, output and approved floor finish for the exact kit before ordering.